Olight Seeker 2 (2019) review
The Olight Seeker 2 (SEEKER2) released in 2019. It uses 3 x Osram P9 LEDs, TIR reflector and 1 x special 21700 Li-Ion battery. The powerful emitter in this flashlight provides up to 3000 lm output, 12100 cd intensity, and a beam distance of 220 m.
It uses a TIR lens to form the beam pattern. This light has 5 modes of lighting. The memory function is a nice feature, the light will remember the last used mode. It has a strobe function, which is one of the most effective self defense tools available. The Seeker 2 flashlight is rechargeable easily via USB port.
Table of contents:
Olight Seeker 2 (SEEKER2) specifications
- Seeker 2
The aluminium body of flashlight treated with a Type III hard-anodized, anti-abrasive ﬁnish.
- 185 g
- 126 mm
- Body diameter
- 27.5 mm
- Head diameter
- 35 mm
- aluminium alloy with HAIII hard-anodized finish
The emitter of Seeker 2 manufactured by Osram, a German lighting manufacturer. A TIR lens works on the principle of total internal reflection. The TIR lens collimates the LED light into efficient, well-controlled light beams that maximize the usable lumens in the target area.
- 3 x Osram P9 LEDs
- Color temperature
- 6500 K
- electronic side
The throw is the calculated distance in meters at which the flashlight produces a light intensity of 0.25 lux. The candela per lumen (cd/lm) ratio can be used to determine if a flashlight has a spot or flood type beam. Well-focused spot beams can be over 100 cd/lm, tactical flashlights are typically between 20-100 cd/lm, and work lights are less than 10 cd/lm.
- 3000 lm
- 12100 cd
- 220 m
- CD/LM factor
The Seeker 2 has mode memory. Mode memory means that the light will remember the mode you were using when the light was last turned off, and when you turn it on again. The Seeker 2 is tactical strobe ready. The strobe light is disorienting to the person it is aimed at which makes it difficult for them to concentrate.
- 5 modes
- Mode memory
- Ramping mode
The battery indicator lets you know when the battery is low, charging, or fully charged. This flashlight can charge the battery with an integrated charger, and it works with any USB power source. A protected battery is recommended as the light itself does not have low voltage protection (LVP). The built-in thermal control automatically adjusts brightness output to prevent overheating.
- 1 x special 21700 Li-Ion battery
- Battery indicator
- Charger port
- magnetic USB
- Thermal regulation
- AUX LEDs
It comes with a battery. The battery must be fully charged before you first use your Seeker 2. The lanyard prevents accidental loss of the flashlight.
- Package contents
- MCC1A magnetic USB charger cable
special 21700 battery
The performance of the Olight Seeker 2 flashlight is measured according to the ANSI / NEMA FL1 Standard 30 seconds after switching the light on. The ANSI/NEMA FL1 2009 Standard is a set of flashlight performance guidelines.
The specifications above are based on the official data published by the manufacturer, but we also take user reviews into consideration. If you found an error or something lacking in the specifications above for the Olight Seeker 2, then don’t hesite and signal the problem to us.
Olight Seeker 2 (SEEKER2) pictures
If there’s information about the Olight Seeker 2 that you would like to see on this site, then write to our firstname.lastname@example.org address.