Acebeam E10 (2020) review
The Acebeam E10 (E10) released in 2020. It uses 1 x Osram KW CSLNM1.TG LED, 1 x Osram CSLNM1.23 LED, 1 x Osram CSLNM1.F1 LED, TIR reflector and 1 x 26350 Li-Ion battery. The powerful emitter in this flashlight provides up to 760 lm output, 79000 cd intensity, and a beam distance of 562 m.
It uses a TIR lens to form the beam pattern. This light has 3 x 4 modes of lighting. The memory function is a nice feature, the light will remember the last used mode. It has a strobe function, which is one of the most effective self defense tools available.
Table of contents:
Acebeam E10 (E10) specifications
The aluminium body of flashlight treated with a Type III hard-anodized, anti-abrasive ﬁnish.
- 137.4 g
- 91 mm
- Body diameter
- 31 mm
- Head diameter
- 40 mm
- aluminium alloy with HAIII hard-anodized finish
The emitter of E10 manufactured by Osram, a German lighting manufacturer. A TIR lens works on the principle of total internal reflection. The TIR lens collimates the LED light into efficient, well-controlled light beams that maximize the usable lumens in the target area.
- 1 x Osram KW CSLNM1.TG LED, 1 x Osram CSLNM1.23 LED, 1 x Osram CSLNM1.F1 LED
- Color temperature
- 6000 K
- electronic side
The throw is the calculated distance in meters at which the flashlight produces a light intensity of 0.25 lux. The candela per lumen (cd/lm) ratio can be used to determine if a flashlight has a spot or flood type beam. Well-focused spot beams can be over 100 cd/lm, tactical flashlights are typically between 20-100 cd/lm, and work lights are less than 10 cd/lm.
- 760 lm
- 79000 cd
- 562 m
- CD/LM factor
The E10 has mode memory. Mode memory means that the light will remember the mode you were using when the light was last turned off, and when you turn it on again. The E10 is tactical strobe ready. The strobe light is disorienting to the person it is aimed at which makes it difficult for them to concentrate.
- 3 x 4 modes
- Mode memory
- Ramping mode
The E10 cannot charge batteries directly. You may need an external charger to keep your battery going. This flashlight has a built-in low voltage protection (LVP) to prevent damage to the cell from over-discharge, so protected cells are not necessary. The built-in thermal control automatically adjusts brightness output to prevent overheating.
- 1 x 26350 Li-Ion battery
- Battery indicator
- Charger port
- Thermal regulation
- AUX LEDs
It comes with a battery. The battery must be fully charged before you first use your E10.
- Package contents
- 2 x spare o-rings
26350 battery with microUSB
The performance of the Acebeam E10 flashlight is measured according to the ANSI / NEMA FL1 Standard 30 seconds after switching the light on. The ANSI/NEMA FL1 2009 Standard is a set of flashlight performance guidelines.
The specifications above are based on the official data published by the manufacturer, but we also take user reviews into consideration. If you found an error or something lacking in the specifications above for the Acebeam E10, then don’t hesite and signal the problem to us.
Acebeam E10 (E10) pictures
If there’s information about the Acebeam E10 that you would like to see on this site, then write to our firstname.lastname@example.org address.