Mechforce EDC Copper (2020) review
The Mechforce EDC Copper (EDCCOP) released in 2020. It uses 3 x Nichia 219CT LEDs, TIR reflector and 1 x 18350 Li-Ion battery. The powerful emitter in this flashlight provides up to 1300 lm output, 10500 cd intensity, and a beam distance of 205 m.
It uses a TIR lens to form the beam pattern. This light has 4 modes of lighting. The memory function is a nice feature, the light will remember the last used mode. It has a strobe function, which is one of the most effective self defense tools available.
Table of contents:
Mechforce EDC Copper (EDCCOP) specifications
- EDC Copper
- 85.9 mm
- Body diameter
- 27 mm
- Head diameter
- 28.5 mm
The emitter of EDC Copper manufactured by Nichia, a Japanese LED manufacturer. A TIR lens works on the principle of total internal reflection. The TIR lens collimates the LED light into efficient, well-controlled light beams that maximize the usable lumens in the target area.
- 3 x Nichia 219CT LEDs
- Color temperature
- 4500 K
- electronic rear
The throw is the calculated distance in meters at which the flashlight produces a light intensity of 0.25 lux. The candela per lumen (cd/lm) ratio can be used to determine if a flashlight has a spot or flood type beam. Well-focused spot beams can be over 100 cd/lm, tactical flashlights are typically between 20-100 cd/lm, and work lights are less than 10 cd/lm.
- 1300 lm
- 10500 cd
- 205 m
- CD/LM factor
The EDC Copper has mode memory. Mode memory means that the light will remember the mode you were using when the light was last turned off, and when you turn it on again. The EDC Copper is tactical strobe ready. The strobe light is disorienting to the person it is aimed at which makes it difficult for them to concentrate.
- 4 modes
- Mode memory
- Ramping mode
The battery indicator lets you know when the battery is low, charging, or fully charged. The EDC Copper cannot charge batteries directly. You may need an external charger to keep your battery going. This flashlight has a built-in low voltage protection (LVP) to prevent damage to the cell from over-discharge, so protected cells are not necessary. The built-in thermal control automatically adjusts brightness output to prevent overheating.
- 1 x 18350 Li-Ion battery
- Battery indicator
- Charger port
- Thermal regulation
- AUX LEDs
It comes with a battery. The battery must be fully charged before you first use your EDC Copper.
- Package contents
- 18350 battery
The performance of the Mechforce EDC Copper flashlight is measured according to the ANSI / NEMA FL1 Standard 30 seconds after switching the light on. The ANSI/NEMA FL1 2009 Standard is a set of flashlight performance guidelines.
The specifications above are based on the official data published by the manufacturer, but we also take user reviews into consideration. If you found an error or something lacking in the specifications above for the Mechforce EDC Copper, then don’t hesite and signal the problem to us.
Mechforce EDC Copper (EDCCOP) pictures
If there’s information about the Mechforce EDC Copper that you would like to see on this site, then write to our firstname.lastname@example.org address.